DYNACORD V600:4

Opis

4‑channel amplifier, with a total powerTANK capacity of 600 W
dualCOOL convection cooling with additional intelligent fan in case of extreme thermal conditions
ecoRAIL and APD deliver significant reduction in power consumption
Variable Load Drive (VLD) providing the same power into 4 Ω, 8 Ω, 70 V or 100 V
amp‑LINK single cable solution for easy installation

Specifications:

ELECTRICAL:
Total rated output power: 600 W
Number of channels: 4
Rated output power: 4 x 150 W
Output power: 4 Ω / 8 Ω / 70 V / 100 V
Maximum output power per channel (power sharing): 500 W / 600 W / 500 W / 600 W

AMPLIFIER: 4 Ω / 8 Ω / 70 V / 100 V
Nominal Gain (+6 dBu input sensitivity, LEVEL 0 dB): 24.0 dB / 27.0 dB / 33.2 dB / 36.2 dB
Signal to Noise Ratio (A‑weighted, ref. to rated output power, LEVEL 0 dB): > -98 dB / > 100 dB / > 101 dB / > 103 dB
THD+N (1/8 RATED OUTPUT POWER, 1 KHz): < 0.1 %

CONNECTIVITY:
Type: 2 x 6-pin Euroblock, 3.81 mm, male, parallel 1x RJ45 (AES72-1E)
Loudspeaker output: 2 x 4-pin Euroblock, 5.08 mm, female
Control port type: 1 x 5-pin Euroblock, 3.81 mm, male

GENERAL:
Signal processing: Input Routing, Filter (24 dB/Oct.), Hi-pass 30/50/100/150 Hz, Lo-pass 150 Hz, Peak Limiter
Power requirements: 100 V to 240 V, 50 Hz to 60 Hz AC
Power consumption:
Idle mode (ecoRAIL with no input signal): < 20 W
Consumption at 1/8 rated output power: 115 W
Standby mode (APD active): < 1 W
Protections: Audio limiters, high temperature, DC, HF, short circuit, back-EMF, peak current limiters, inrush current limiters, mains over/under voltage protection